How To program your Atmega with Jeepers

Connect your atmega to the parallel port of your computer. Then follow the steps outlined below.

1. Select the proper pfg file.
2. Select the proper board type. Use ATmega128@18.4320MHz
3. Hit the GET button under the keys section. You need to be connected to the internet to retrieve the latest keys
   
   
   
4. Enter your IRD# this is the number on the back of your receiver starting with R 00
5. Enter your Box keys which can be found using the JTAG reader.
6. Enter your time zone
7. Enter your zip code or 12345
8. Click the Full Monty button.

Remove the card from the programmer and place it in your receiver. It may take a few moments for the keys to roll.

Back to support pages